EVGA Hadron Air Betriebsanweisung PDF herunterladen (Seite 5)

8 9

Installing the PCI-E Graphics Card

Connecting Front Panel LED / USB / Audio Headers

▪ Unscrew the retention clip on the backside of

the chassis, and ﬂip the clip down.

▪ Unscrew the screw.

▪ Insert the graphics card.

▪ Place screw back in, ﬂip up retention clip and

screw in.

▪ Connect power adapters to graphics card.

▪ Connect the Power LED and Power Switch

cables. Make sure that the Power LED is in

the correct +/- orientation. Please consult your

motherboard documentation on the proper

location for connection.

▪ The USB 3.0 Internal Cable allows for full

support of USB 3.0 devices, please consult

your motherboard documentation to properly

connect this.

▪ The HD audio connector supports HD Audio,

please consult your motherboard

documentation on the proper location of

connection.

Optical drive installation (optional)

Fan installation / replacing

▪ If you wish to install a slim slot load optical

drive, you can by ﬁrst removing the opposite

cover.

▪ Insert the optical drive into the optical drive tray

and attach four screws.

▪ Slide in the optical disc tray.

▪ EVGA recommends using the Panasonic

UJ8C5 Slot Load Optical drive.

▪ The bundled fans connect to standard 3pin fan

headers on your motherboard.

▪ If you need to service / replace the included

fans, you can do so by ﬁrst removing the top

cover.

▪ Remove both screws located on the backside

of the chassis.

▪ Slide out the top cover in a horizontal fashion.

English English

1 2 3 4 5 6 7 8 9 10 ... 37 38

Keine Kommentare

EVGA Hadron Air Betriebsanweisung Seite 5